Install Insert
0 mins to read
Geotab IOX-WRKS Installer LED Tool Guide
Install Insert
0 mins to read
This document provides information about the Geotab IOX-WRKS installation process with an optional add-on LED tool. As an installer, it is your responsibility to complete the actions outlined in the official IOX-WRKS Installation Guide before installing the USB-powered LED lamp into the IOX-WRKS harness.
April 2023
Introduction
This document provides information about the Geotab IOX-WRKS installation process with an optional add-on LED tool.
Getting Started
As an installer, it is your responsibility to complete the actions outlined in the official IOX-WRKS Installation Guide before installing the USB-powered LED lamp into the IOX-WRKS harness.
Stages
Stages of the USB LED Lamp:
Stage | LED Pattern | Meaning |
0 | OFF | No power to IOX-WRKS |
1 | 1 blink | Power to IOX-WRKS |
2 | 2 blinks | System is Healthy, but not configured yet |
3 | 3 blinks | Set Spreader Worked (configuration is not the default) |
4 | Inverted 1 blink | Received Data from Spreader Controller |
5 | Flickering | Received Ack from MyGeotab |
Geotab Public Works Support
Geotab Public Works Support Contact Information | ||
Phone Number | 1-800-984-6175 | |
Hours of Operation | Monday to Friday — 7:30 a.m. to 8:00 p.m. EST Saturday — 11:00 a.m. to 7:00 p.m. EST | |
Geotab Public Works Support will assist the Installer with the following when on-site:
- Receive installation-related support.
- Apply the appropriate controller configuration file when required.
- Verify and validate the installation before leaving the installation site.
Supported USB LED Devices
Any 5V single-light USB LED device is supported. The program controlling the LED is generic and only controls the voltage supplied to the USB port.
The IOX-WRKS device can light up any LED lamp attached to the USB Host wire of its wiring harness.
Troubleshooting
I don’t see any light at all, and I expect to.
It will be one of these scenarios:
- There might be no power getting to the IOX-WRKS. If there are no lights on the GO device, fix that first. Only after all 3 lights are on the GO: red, green, and blue, does the IOX-WRKS function. If that is ok, then
- Unplug the Mini-USB cable from the GO device, then plug back in again and make sure it is seated well. It also helps to wrap a zip strap tie around it. If that doesn’t fix it, then
- The USB LED Light itself might be faulty. Try replacing your USB LED lamp with a different one. Also, the Dollar Store has USB charging cables that light up. Those ones seem to be more reliable than the little reading lights.
- If needed, replace the cable coming from the IOX-WRKS, with a new one, that plugs into the GO device.
- If nothing above works, then you might need a new IOX-WRKS device.
